chongqing spot high pressure boiler tube spot

Catastrophic tube failure engulfs boiler building in high ...

Oct 12 2018 · A severe tube rupture occurred on a high pressure steam boiler which was operating at 750 pounds per square inch shortly following a warm-up period on start-up. A catastrophic tube failure caused a release of a significant portion of the 40000 liters of water in the boiler in approximately one minute. The inside of the entire four storey boiler building was engulfed in high temperature steam.

Learn More

Tubes Erosion Shields Tube shields erosion shields

The snap ring and Boiler Tubes Erosion Shields are overlapped and welded generally about 190-200 degrees Erosion Shields is a 180-degree semicircle) but also leave a welding position for easy welding and fixing. Generally each piece of Boiler Tubes Erosion Shields needs to be equipped with 2-4 snap rings with a pitch of 200-500mm.

Learn More

HRSG inspection maintenance and repair - ScienceDirect

Jan 01 2017 · FAC occurs predominantly in the tubes headers and risers of low-pressure evaporators and in the tubes and headers of economizers and feedwater preheaters operating in the 200500°F temperature range. It occurs in areas where the velocity of the water or water/steam mixture is high such as bends in tubes or risers or tube-to-header joints.

Learn More

How to Address a Leaking Boiler | Powerhouse Boiler Equipment

Pressure Relief Valve. The pressure relief valve protects the boiler system from building up too much pressure. If the pressure is too high then the boiler will release steam and water. Should this happen there could be significant damage so it is important to identify and treat this issue as soon as possible.

Learn More

Boiler Inspection - Sigma NDT Services

If a boiler burns coal many times a quality high-pressure water blast is all that is necessary. For the inspection of the waterwalls we use the Tube Scanning system based on Low Frequency Electromagnetic Technique (LFET). Our LFET technology scans approx. 120 degrees of the tube circumference with a single pass of the LFET scanner.

Learn More

On the Mechanism of Formation of Hot Spots in Boiler Tubes ...

Through a careful failure investigation of boiler tubes that suffered from corrosion due to hot spot formation an attempt was made to clarify some ambiguities about the sequence of events that ...

Learn More